InfoDrainage

Showing 117 of 1036

Import method specific Inflow parameters

With the various hydrology methods requiring additional parameters, it would be helpful to allow a feature to import these as GIS attributes. As methods such as SCS are widely used in the United States and require initial abstraction and curve num...

Sam Redway 2 months ago in InfoDrainage / Hydrology 1 Gathering support

8 VOTE

Manhole Schedule Numbering

For MH tables and report outputs, it would be good to have an option to report chronologically, e.g. 1-30. I understand it numbers them on the first Manhole built in the model however I think it would make more sense to go from shallowest to deep...

Guest over 1 year ago in InfoDrainage 3 Already exists

8 VOTE

InfoDrainage - level bench in basin/pond configuration

The sizing calculator in the pond build pop-up enables one side lpe only. There are now LLFAs that require level benck of at aleast 1.5 m width after 0.6 m depth in a basin. It is currently not possible to use your calculator to establish such b...

Guest over 1 year ago in InfoDrainage 2 Gathering support

8 VOTE

InfoDrainage - Re-Ordering Tables

Please can you add an ability to manually adjust the order of Junctions and Connections as the tables quickly become difficult to follow. The automatic re-ordering seems to reset as soon as you make any changes!

Guest over 1 year ago in InfoDrainage 1 In progress

1 VOTE

Infiltration Trench using BRE DIGEST 365 method

The software needs to support for designing Infiltration trench method by using “BRE DIGEST 365”. I have checked the comparison between Infodrainage analysis Vs BRE digest 365 (manual calculation) and the results are not matching. Most of the proj...

Guest 3 months ago in InfoDrainage / Hydraulics 8 Gathering support

4 VOTE

dendric numbering and table of results

its frustrating when interrogating and amending the pipe network, when the pipes and chambers are not in the same order, the way it was presented in MicroDrainage gave a clear path with the final outfall pipe being at the bottom, not randomly plac...

Steven Gilchrist 11 months ago in InfoDrainage / Reporting 1 Under consideration

4 VOTE

Add Snowmelt to InfoDrainage

The addition of SWMM5 snowmelt will make it easier to model LID's in North America which has a lot of snowfall in Canada and the northern USA. Snowmelt can be a significant source of water annually to a LID or SuDS.

ROBERT DICKENSON 11 months ago in InfoDrainage / Hydrology 1 Under consideration

3 VOTE

Modelling intermediate check dams and weirs in open channels including ponds ands swales

Currently, InfoDrainage only allows modeling of check dams or weirs at outlets. For open channels with multiple intermediate check dams, users must split the channel into sections, each with its own outfall defined. A more accurate feature allowin...

Dilraj KT 9 months ago in InfoDrainage / Hydraulics 1 Gathering support

6 VOTE

Exceedance Level in Infodrainage

It would be good to have an option in underground stormwater controls to have a separate option for exceedance level and Ground Level By taking the exceedance level as GL, it makes the Long sections look distorted when in reality it is common for...

Guest over 1 year ago in InfoDrainage 1 Already exists

6 VOTE

InfoDrainage - Permeable Paving

It would be useful to have a central granular conveyance trench beneath permeable paving to avoid the need for overly deep sub base beneath the road / drive.

Guest over 1 year ago in InfoDrainage 1 Already exists

Please enter your email address

FILTER BY CATEGORY